• PowerWave data capture – capture fast RMS values to see every waveform so you can determine how the voltage, current and frequency values are interacting
• Power inverter efficiency – Power inverter efficiency
• Energy monetization – calculate the fiscal cost of energy waste due to poor power quality
• Energy assessment – quantify the before and after installation improvements in energy consumption to justify energy saving devices
• Frontline troubleshooting – quickly diagnose problems on-screen to get your operation back online
• Predictive maintenance – detect and prevent power quality issues before they cause downtime
• Long-term analysis – uncover hard-to-find or intermittent issues
• Load studies – verify electrical system capacity before adding loads

• Power inverter efficiency: Simultaneously measure AC output power and DC input power for power electronics systems using optional DC clamp.
• PowerWave data capture: Capture fast RMS data, show half-cycle and waveforms to characterize electrical system dynamics (generator start-ups, UPS switching etc.).
• Energy loss calculator: Classic active and reactive power measurements, unbalance and harmonic power, are quantified to pinpoint the fiscal costs of energy losses.
• Troubleshoot real-time: Analyze the trends using the cursors and zoom tools.
• Highest safety rating in the industry: 600 V CAT IV/1000 V CAT III rated for use at the service entrance.
• Measure all three phases and neutral: With included four flexible current probes with enhanced thin flex design to fit into the tightest places.
• Automatic Trending: Every measurement is always automatically recorded, without any set-up.
• System-Monitor: Ten power quality parameters on one screen according to EN50160 power quality standard.
• Logger function: Configure for any test condition with memory for up to 600 parameters at user defined intervals.
• View graphs and generate reports: With included analysis software.
• Battery life: Seven hours operating time per charge on Li-ion battery pack.

• 430 Series Comparison Guide

Supplied with:

• Documentation and Software on USB stick:
  • PDF User Manual
  • PDF Flexible AC Current Probe Instructions
  • PDF Software Release Notes
  • PDF Copy and Backup Data from Fluke 43X Series
  • Power Log Software
  • USB Fluke 43X Series USB Drivers
• User Manual (hard copy)
• USB Cable A-B mini
• 8GB SD Card (installed)
• Qty 4 x i430-Flex-TF, 61cm length 6000A RMS Current Clamps
• Qty 5 x L430 Test lead and Alligator Clip Set
• BP290 Li-ion Battery Pack (installed)
• BC430 240V Power Adapter
• Soft Carry Bag
• Certificate of Calibration
• Transit Case

Product Videos:



More videos:

• How to transfer data to the PowerLog PC software
• Logging capture and sample rate
• How to perform a transient capture
• How to perform a trend configuration
• How to connect using the Phasor Diagram
• How to check for dips and swells
• How to use a Harmonics Test
• How to configure the Energy Loss Calculator on a Fluke 430-series